Place Styrofoam cups upside down (open end of cup down) on a dark coated cookie sheet, placing them about 1-2" apart. Note: we experimented with both dark coated and silver cookie sheets, the cups did not melt properly on the silver sheets.
Bake in the oven for approximately 3 minutes, don't walk away! It will take about one minute before you see any changes to the cups, then the heat will begin to melt and shrink them rather rapidly after that. It's lots of fun for the kids to watch, so be sure to turn the oven light on.
Remove the cookie sheet from the oven and set aside to cool completely. DO NOT try to remove the cups from the cookie sheet until they are completely cooled. As they cool, the Styrofoam that is stuck to the sheet will relax and release its grip from the sheet, allowing you to remove them easily. Most cups will melt rather well, thought you may end up with one or two that look rather distorted or disfigured.
Paint the "hats" with green paint, one coat is usually enough, and allow them to dry completely. Once they are dry paint a black rim around the hat and allow to dry again.
Mean while, take a gold chenille stem and bend it into a square or rectangle for the hat's buckle, trim end off with scissors. When paint is dry, hot glue the buckle to the front of the hat on the black rim. Hot glue a shamrock shaped button to the top portion of the front of the hat.
If you like, you can hot glue a small round magnet to the bottom of the hat at the brim and hang on the refrigerator.
This project for Styrofoam Cup Leprechaun Hats was printed from CraftsbyAmanda.com - https://craftsbyamanda.com/styrofoam-cup-leprechaun-hats/ and can only be printed for education or personal use.