Iron the denim strip to remove any creases or wrinkles. Trim to the width you want your ring to be. Fray the edges of the denim strip by pulling strands of the denim off one at a time.
Thread the needle with stretchy jewelry cord and knot the end. Poke the needle through the center of the denim and pull until the knot touches the back of the denim.
Use the tip of the needle to pick up the seed beads. Push the seed beads down the needle past the eye and onto the cord. Push the beads all the way down until the reach the denim. Keeping the beads together, lay them down onto the denim to gauge where to insert your needle. Run the needle through the denim then back up through again and repeat for a second row and finally a third row. Tie off the cord at the back and secure with a small amount of hot glue.
Wrap the denim strip around your finger to gauge the size. Trim, allowing a little excess so you have room to glue the ends together. Use hot glue to secure the ends creating your ring.
This project for Denim Beaded Ring was printed from CraftsbyAmanda.com - https://craftsbyamanda.com/denim-beaded-ring/ and can only be printed for education or personal use.