Print Project

Peacock Duck Tape Business Card Holder

Prep Time45 mins
Total Time45 mins

Supplies

  • Peacock Duck Tape
  • Glitter Duck Tape: Aqua and Silver
  • 1 set Velcro enclosures
  • Craft knife
  • Cutting mat

Instructions

  • We need to make what is called a fabric sheet. It's easiest if you use a cutting mat for this. Measure and cut an 8 1/2-inch piece of peacock tape. Measure and cut a second piece the same length and slightly overlap it on the long edge. Stick them together by pressing it with your fingers. Repeat for a fourth strip of tape.
  • Use your craft knife to lift the corner of the bottom strip and peel it up and off of the cutting mat. Turn the sheet over so that it is sticky side up. Measure and cut another strip of peacock tape the same length as the previous three. Line up the edges with the bottom strip and stick it to the sheet. Repeat with two more strips to make the sheet complete.
  • Trim the sheet to measure 4 1/2-inches x 8 1/4-inches.
  • Measure and cut a 5-inch piece of Aqua glitter tape. Cut it into 1/4-inch strips (one will be a little smaller than the others).
  • Use two of these strips to cover the short sides of the sheet. Equal amounts of tape should show on both sides, overlapping and creating a clean edge. Trim off the small overlapping edges.
  • To give this holder its shape, fold the sheet in half and crease it. Open it back up and fold each end up by 1 1/2-inches.
  • I hope this isn't confusing. I apparently did not take a picture of this step with the peacock holder, but I did with the other one made from glitter tape. This kind of shows what I'm taking about. We are creating the pockets, which is just the sheet folded upward over the card.
  • Before we close it all up, we are going to add the glitter stripes. With the sheet folded, turn it over and stick two glitter strips across the sheet. The edges will fold over and won't be seen because they will be inside the pockets.
  • Cut a strip of silver glitter tape, 4 1/2-inches long, then cut it in half lengthwise. The final strip will measure 1-inch x 4 1/2-inches.
  • Stick the silver glitter tape across the center crease of the sheet.
  • Measure and cut a 5 1/2-inch strip of peacock tape. Cut that strip in half lengthwise.
  • To close up and complete the holder, turn it over so that the pocket folds are facing up. Be sure that all the glitter strip ends have been folded over and pressed into place. Fold the pockets in place and seal the edges with one of the peacock strip halves. Repeat on the other side. The last step is to attach Velcro enclosures to keep the holder closed. I used self adhesive Velcro and it didn't hold very well. Therefore I cut small strips of peacock tape and secured the Velcro in place and it worked like a charm!